NO FOLDER OPTIONS / SEARCH OPTION :

If there is no Folder Options / Search Option in no doubt there is some malware in your system. Just download some malware remover like ‘mbam.exe’ and run it.

One thing to note is that it's quite possible that if you're in an environment managed by a centralized policy, these settings may have no effect. Your IT administrator may set things up so as to disable Task Manager, and other things as well at the domain level. You'll need to ask them if this is the case.

PING not recognized

If Ping not recognized error is coming just type 'Set'

Set

check whether Path C:\WINDOWS\system32

If not found in the command prompt type : path=C:\WINDOWS\system32

Thats it the things is over

http://payingptr.com/pages/index.php?refid=sengueny

System.EXE Error

If your system is giving some popups with system.exe, then it is seriously infected by a spyware / Trojan. To overcome this a download a free version of TROJAN REMOVER http://www.simplysup.com/tremover/download.html which is available with 30 days validation and solve the issue.

NET SEND for console message transmission

This is a command used to send messages through out the network
Syntax : NET SEND {name * /DOMAIN[:name] /USERS} message
Example : NET SEND auro This is a test message
Common problems in it : Error 2273 and 2136
Soultions : First enable the messenger services for all the PCs. This can be done by Start -> Run -> type services.msc
In the pop up locate messenger, in the start type select Automatic and start the service.

How to set up Internet in Local Area Network

Use Proxy System
There are lots of proxy available for download in free such as Analog Proxy, CCProxy, etc. There are many draw backs in using Proxies. The proxy installed PC should be kept ON always for other computers to work internet. Also, some proxies restrict gives access to few pcs only. Some is hard to config work with outlook express and MS outlook.

To overcome the above, the following can be done.

Setting each PC to access internet separately.

First complete as usual connections with the modem like power chord & telephone line.Then take a separate line from modem and connect the other end to the router / switch. network lines are connected.

Now, configure the system which needs internet as below :
Let us assume that the following may be interproviders IP setup
Now open the network properties (step as given above) of the PC which needs to access internet.
Click Advanced and in the IP settings then Add and enter IP address as ‘192.168.1.10’
In default Gateway click add and enter 192.168.1.1

Network / Internet Configuration

How to set up Network :

• Click on Start


• Select Run


• Type ncpa.cpl and press enter









• Right-click on Local Area Connection and select Properties.
  Note: If "Local Area Connection" is not listed, your ethernet card is not currently detected by Windows XP, use the Add/Remove Hardware control panel to install your Ethernet card for use with Windows XP.

• Click the General tab and make sure that the list of installed components includes Internet Protocol (TCP/IP).


• If Internet Protocol (TCP/IP) is not listed:


• Click Install.


• Select Protocol and click Add.


• Select Internet Protocol (TCP/IP) and click OK.


• Click Yes to reboot your computer, then begin the configuration process again with step 1.
  Highlight Internet Protocol (TCP/IP) by clicking on it once (do not uncheck it!) and click the Properties button.


• Type the IP address & Subnet mask also Gateway and DNS if required.


• Click OK.

Thats all your network is ready.